The development of a combined surface adhesion and polymerase chain reaction technique in the rapid detection of Listeria monocytogenes in meat and poultry

Survival of Listeria innocua on hot and cold beef carcass surfaces

AIMS

This study aimed to determine the survival and growth of Listeria innocua on hot and cold beef carcass surfaces.

METHODS AND RESULTS

Four sites, the neck, outside round, brisket and foreshank/brisket, were inoculated with L. innocua (i) immediately after dressing while hot and (ii) when cold after chilling. After inoculation, all carcasses were stored at 4 degrees C for 72 h. Survival of L. innocua on cold surfaces declined during storage and was less than on hot carcasses at all times. Data on the survival of L. innocua in broth (maximum recovery diluent) indicated that counts could not be compared with those on carcasses, in particular on cold carcasses.

CONCLUSIONS

The results indicate that L. innocua survives on hot carcass surfaces during chilling, but declines over time on cold surfaces. The decrease in L. innocua counts on cold surfaces may be related to a synergy between the combined stresses of low available water (a(w)) and low temperature.

SIGNIFICANCE AND IMPACT OF THE STUDY

This study is the first to determine the effect of chilling on the survival and growth of Listeria on beef carcass surfaces. The information can potentially be used to determine the survival and growth of the pathogen, L. monocytogenes on beef surfaces.

Methods for the isolation and identification of Listeria spp. and Listeria monocytogenes: a review

Listeria monocytogenes is an important food-borne pathogen and is widely tested for in food, environmental and clinical samples. Identification traditionally involved culture methods based on selective enrichment and plating followed by the characterization of Listeria spp. based on colony morphology, sugar fermentation and haemolytic properties. These methods are the gold standard; but they are lengthy and may not be suitable for testing of foods with short shelf lives. As a result more rapid tests were developed based on antibodies (ELISA) or molecular techniques (PCR or DNA hybridization). While these tests possess equal sensitivity, they are rapid and allow testing to be completed within 48 h. More recently, molecular methods were developed that target RNA rather than DNA, such as RT-PCR, real time PCR or nucleic acid based sequence amplification (NASBA). These tests not only provide a measure of cell viability but they can also be used for quantitative analysis. In addition, a variety of tests are available for sub-species characterization, which are particularly useful in epidemiological investigations. Early typing methods differentiated isolates based on phenotypic markers, such as multilocus enzyme electrophoresis, phage typing and serotyping. These phenotypic typing methods are being replaced by molecular tests, which reflect genetic relationships between isolates and are more accurate. These new methods are currently mainly used in research but their considerable potential for routine testing in the future cannot be overlooked.

Comparison of a membrane surface adhesion recovery method with an IMS method for use in a polymerase chain reaction method to detect Escherichia coli O157:H7 in minced beef

In this study, enrichment procedures and two recovery methods, a membrane surface adhesion technique and an immunomagnetic separation (IMS), were compared for use in conjunction with a multiplex polymerase chain reaction (PCR) method with a view to describing a fast (24 h) and economical test for detection of Escherichia coli O157:H7 in meat samples. The study showed no significant difference between three different enrichment media (BHI, E. coli (E.C.) broth+novobiocin, modified tryptone soya broth (mTSB)+novobiocin) or two incubation temperatures (37 or 41.5 degrees C) for growth of E. coli O157:H7 in minced beef. Minced beef samples inoculated with E. coli O157:H7 at 40 cfu g(-1) were incubated at 37 degrees C for 16 h in E.C. broth+novobiocin reaching numbers of (log(10)7.82-8.70). E. coli O157:H7 were recovered by attachment to polycarbonate membranes immersed in the enriched cultures for 15 min or by immunomagnetic separation. Subsequent treatment of recovered membranes or IMS beads with lysis buffer and phenol/chloroform/isoamyl alcohol was used to extract the DNA from the extracted E. coli O157:H7 cells. The results show when E. coli O157:H7 was present at high levels in the enriched meat sample (log(10)9.6-7.5 cfu ml(-1); >16-h enrichment), the membrane and IMS techniques recovered similar levels of the pathogen and the microorganism was detectable by PCR using both methods. At lower levels of E. coli O157:H7 (log(10)6.4), only the IMS method could recover the pathogen but at levels below this neither method could recover sufficient numbers of the pathogens to allow detection. The conclusion of the study is that with sufficient enrichment time (16 h) the membrane surface adhesion membrane extraction method used in combination with multiplex PCR has the potential for a rapid and economical detection method.

Application of real-time PCR and RT-PCR assays for the detection and quantitation of VT 1 and VT 2 toxin genes in E. coli O157:H7

Real-time PCR assays, based on hybridisation probes and LightCycler technology, were developed for VT 1 and VT 2 genes and applied to the detection and quantitation of DNA and mRNA of Escherichia coli O157:H7. The qualitative consensus PCR assay for the detection of VT 1 and/or VT 2 genes had a detection limit of 100 fg of E. coli O157:H7 genomic DNA and did not detect DNA from 13 non-VTEC isolates. When E. coli O157:H7 was inoculated into minced beef, enriched and recovered by immunomagnetic separation, the real-time consensus PCR assay had a detection limit of log(10)3.5 ml(-1) E. coli O157:H7 cells. Nineteen E. coli O157:H7 isolates, derived from food, bovine samples and human faeces, were analysed and compared for mRNA expression of three genes, VT 1, VT 2 and gapA (housekeeping gene), using quantitative real-time PCR assays. While there was no statistically significant difference for the expression of the VT 1 (p=0.134) or VT 2 (p=0.52) mRNA in the E. coli O157:H7 isolates from food, bovine and human sources, three clinical isolates did show lower expression of VT 2 compared to other isolates in the study. The study indicates that the consensus qualitative real-time PCR assay for VT 1 and VT 2 is rapid and sensitive and that the quantitative assays reported here have the potential to be used as an alternative method to more conventional methods for studying VT 1 and VT 2 virulence gene expression in E. coli O157:H7 with potential application in other pathogenic E. coli species.

Comparison of a cultural method with ListerScreen plus Rapid'L.mono or PCR-ELISA methods for the enumeration of L. monocytogenes in naturally contaminated sewage sludge

Cultural methods used to count Listeria monocytogenes in sewage sludge are laborious and time consuming, and alternative methods are needed to reduce analysis time and improve detection limits. In this study, a survey of L. monocytogenes in sewage sludge is presented with a comparative study between a cultural method and immunomagnetic separation using a ListerScreen test followed by identification of L. monocytogenes with Rapid'L.mono agar or PCR-ELISA. These two alternative methods improved the detection of L. monocytogenes in different types of sludge, irrespective of their physical and chemical characteristics. The ListerScreen method coupled with detection of L. monocytogenes on Rapid'L.mono offers the advantage of being less sophisticated than the molecular method and allows isolation of the organism, which may be useful in epidemiological studies. However, ListerScreen coupled with PCR-ELISA proved best for high-sensitivity detection of L. monocytogenes in sewage samples.

Polymerase chain reaction detection of Listeria monocytogenes on frankfurters using oligonucleotide primers targeting the genes encoding internalin AB

A polymerase chain reaction (PCR) assay targeting the genes encoding internalin AB (inlAB) was developed for detecting Listeria monocytogenes in pure cell cultures and on artificially contaminated frankfurters. Four sets of oligonucleotide primers were evaluated. The set targeting a 902-bp region of the inlAB gene was the most specific. This PCR product was detected in 51 L. monocytogenes strains belonging to four different serogroups (1/2a, 1/2b, 1/2c, and 4b). In contrast, the PCR product was not detected in other Listeria spp. (Listeria innocua, Listeria ivanovii, Listeria seeligeri, Listeria welshimeri, or Listeria grayi) or in gram-positive, non-Listeria bacteria, indicating that the primer set was highly specific for L monocytogenes. The detection limit of the PCR assay was 10(5) CFU per ml of pure cell culture. However, the assay could detect as few as 10(1) CFU of L. monocytogenes in 25 g of frankfurter with 16 h of enrichment in modified Listeria enrichment broth at 30 degrees C. The total assay time including enrichment was approximately 24 h. These results suggest that the PCR assay can be used to rapidly detect L. monocytogenes on frankfurters and possibly other types of ready-to-eat meat products.

Development and application of new nucleic acid-based technologies for microbial community analyses in foods

Several challenges still persist in the analysis of microorganisms in foods, particularly in studies of complex communities. Nucleic acid-based methods are promising tools in addressing new questions concerning microbial communities. We have developed several new methods in the field of nucleic acid-based microbial community analyses. These methods cover both sample preparation and detection approaches. The sample preparation method involves simplified DNA purification using paramagnetic beads. As an extension of this method, the same paramagnetic beads are used for both cell separation and DNA purification. This enables full automation. The separate detection of viable and dead bacteria is a major issue in nucleic acid-based diagnostics. We have applied a living/dead dye that binds covalently to DNA and inhibits the PCR from dead cells. In addition, a DNA array-based detection assay has been developed. The assay combines the specificity obtained by enzymatic labeling of DNA probes with the possibility of detecting several targets simultaneously by DNA array hybridization. In combination with 16S rDNA amplification, this is a promising tool for community analyses. Also, we have developed a novel approach for multiplex quantitative PCR. The multiplex PCR has been combined with our DNA array-based detection method. Finally, we are now in the process of adapting a system for monitoring microbial growth and death in real-time through the tagging of bacteria with green fluorescent protein (GFP) combined with fluorescence detection using a high-resolution confocal laser scanner.

Application of a multiplex polymerase chain reaction assay for the simultaneous confirmation of Listeria monocytogenes and other Listeria species in turkey sample surveillance

A multiplex polymerase chain reaction was developed to simultaneously identify Listeria monocytogenes and species of the genus Listeria. Two sets of primers were used, with the first amplifying a 938-bp region of the 16S rRNA gene that is highly conserved in all Listeria species and the second amplifying a 174-bp region of the listeriolysin (hlyA) gene of L. monocytogenes. Thus, isolates of Listeria spp. yield a single 938-bp product, whereas L. monocytogenes isolates yield both the 938-bp product and a 174-bp product. The specificity of the assay was verified with all six Listeria species and 11 serotypes of L. monocytogenes, as well as nonrelated bacteria. The multiplex PCR assay was used to determine the incidence of Listeria spp., especially L. monocytogenes, in mechanically separated turkey samples (n = 150 samples). L. monocytogenes strains were selected by using the University of Vermont two-step enrichment protocol and plating to selective Palcam agar. The multiplex PCR assay was used for verification of presumptive Listeria colonies. Approximately 38% of mechanically separated turkey samples (57 of 150) yielded L. monocytogenes; an additional 18% of these samples (27 of 150) harbored other Listeria spp. Fifty-one percent (29 of 57) of the L. monocytogenes isolates were of serogroup 1, 44% (25 of 57) were of serogroup 4, and 2% (1 of 57) were assigned to serogroups other than 1 and 4.

Applications of biochemiluminescence to HACCP

The hazard analysis critical control point) (HACCP) system is set up with the aim of ensuring the harmlessness of food along the process chain, from the producer to the ultimate consumer. To set up this system, it is necessary to perform an analysis to identify the dangers and the critical points of the process in real time. Living organisms are detected on the principle of measurement of cellular energy in the form of adenosine triphosphate (ATP), which is produced by all living cells and of particularly by microorganisms. The principle of the bioluminescence of firefly luciferase is applied, whereby a reduced form of luciferin, together with a molecule of oxygen and ATP in the presence of the enzyme luciferase, produces a reaction in which oxyluciferine is released, together with AMP. This is accompanied by a simultaneous release of photons, which are then quantified. The emission spectra recorded with the firefly luciferin/luciferase system is obtained with absolute sensitivity. The method of ATP assays here proposed is adapted for measuring the total content of different adenylates in the cell, i.e. the adenylate pool. ATP concentration is then measured through bioluminescence, i.e. the light is measured by a photomultiplier tube detector and the signal is converted to relative light units (RLU). Thus, RLU have a relationship with the amount of ATP present in the sample, which is not the case with traditional methods. Adequate levels of sensitivity are calculated with appropriate controls and the readings are translated into a statistical designation of positive or negative result. There are numerous illustrations of HACCP applications using biochemiluminescence (BCL) techniques as detection technology in food industry production lines and in control of critical points in real time in industrial applications.