Transport mechanisms in Co-doped ZnO (ZCO) and H-irradiated ZCO polycrystalline thin films

Sensitivity Enhancement of CO2 Sensors at Room Temperature Based on the CZO Nanorod Architecture

Cobalt-doped ZnO (CZO) thin films were deposited on glass substrates at room temperature by radio frequency (RF) magnetron sputtering of a single target prepared with ZnO and Co3O4 powders. Changes in the crystallinity, morphology, optical properties, and chemical composition of the CZO thin films were investigated at various sputtering powers of 45, 60, and 75 W. All samples presented a hexagonal wurtzite-type structure with a preferential c-axis at the (002) plane, along with a distinct change in the strain values through X-ray diffraction patterns. Scanning electron and atomic force microscopy revealed uniform and dense deposition of nanorod CZO samples with a high surface roughness (RMS). The Hall mobility and carrier concentration increased with the introduction of Co+ ions into the ZnO matrix, as seen from the Hall effect study. The gradual increase of the power applied on the target source significantly affected the morphology of the CZO thin film, which is reflected in the CO2-sensing performance. The best gas response to CO2 was recorded for CZO-60 W with a response of 1.45 for 500 ppm CO2, and the response/recovery times were 72 and 35 s, respectively. The distinguishing feature of the CZO sensor is its ability to effectively and rapidly detect the CO2 target gas at room temperature (∼27 °C, RT).

Mesoscopic 3D Charge Transport in Solution-Processed Graphene-Based Thin Films: A Multiscale Analysis

Graphene and related 2D material (GRM) thin films consist of 3D assembly of billions of 2D nanosheets randomly distributed and interacting via van der Waals forces. Their complexity and the multiscale nature yield a wide variety of electrical characteristics ranging from doped semiconductor to glassy metals depending on the crystalline quality of the nanosheets, their specific structural organization ant the operating temperature. Here, the charge transport (CT) mechanisms are studied that are occurring in GRM thin films near the metal-insulator transition (MIT) highlighting the role of defect density and local arrangement of the nanosheets. Two prototypical nanosheet types are compared, i.e., 2D reduced graphene oxide and few-layer-thick electrochemically exfoliated graphene flakes, forming thin films with comparable composition, morphology and room temperature conductivity, but different defect density and crystallinity. By investigating their structure, morphology, and the dependence of their electrical conductivity on temperature, noise and magnetic-field, a general model is developed describing the multiscale nature of CT in GRM thin films in terms of hopping among mesoscopic bricks, i.e., grains. The results suggest a general approach to describe disordered van der Waals thin films.

Electrical conduction and noise spectroscopy of sodium-alginate gold-covered ultrathin films for flexible green electronics

Green electronics is an emerging topic that requires the exploration of new methodologies for the integration of green components into electronic devices. Therefore, the development of alternative and eco-friendly raw materials, biocompatible and biodegradable, is of great importance. Among these, sodium-alginate is a natural biopolymer extracted from marine algae having a great potential in terms of transparency, flexibility, and conductivity, when functionalized with a thin gold (Au) layer. The electrical transport of these flexible and conducting substrates has been studied, by DC measurements, from 300 to 10 K, to understand the interplay between the organic substrate and the metallic layer. The results were compared to reference bilayers based on polymethyl-methacrylate, a well-known polymer used in electronics. In addition, a detailed investigation of the electric noise properties was also performed. This analysis allows to study the effect of charge carriers fluctuations, providing important information to quantify the minimum metallic thickness required for electronic applications. In particular, the typical noise behavior of metallic compounds was observed in samples covered with 5 nm of Au, while noise levels related to a non-metallic conduction were found for a thickness of 4.5 nm, despite of the relatively good DC conductance of the bilayer.

Role of the carrier density in the transport mechanisms of polycrystalline ZnO films

The transport processes occurring in polycrystalline ZnO have been investigated by measuring the resistivity as a function of temperature in ZnO films with different n-doping levels, obtained by varying the oxygen pressure during the deposition process. These films show an electrical resistivity spanning about two orders of magnitude, from 4 to 8 × 10^-2Ω cm at room temperature, corresponding to low and high levels of n-type doping, respectively. The present results indicate a relevant role of the carrier density in determining the dominant transport mechanisms in these samples by showing that the picture characterizing a highly n-doped ZnO sample, where an intra-grain mechanism and a grain-boundary mechanism dominate the high temperature and low temperature transport processes, respectively, is thoroughly overturned in lightly n-doped samples, where a grain-boundary mechanism and an intra-grain mechanism govern the charge transport in the same temperature regimes, respectively. Moreover, the present results indicate a critical role of the conditions limiting the occurrence of the Mott variable range hopping regime. They show indeed that an incomplete check of such conditions can result in erroneous conclusions about the prevalent transport mechanisms.

Electric Transport in Gold-Covered Sodium-Alginate Free-Standing Foils

The electric transport properties of flexible and transparent conducting bilayers, realized by sputtering ultrathin gold nanometric layers on sodium-alginate free-standing films, were studied. The reported results cover a range of temperatures from 3 to 300 K. In the case of gold layer thicknesses larger than 5 nm, a typical metallic behavior was observed. Conversely, for a gold thickness of 4.5 nm, an unusual resistance temperature dependence was found. The dominant transport mechanism below 70 K was identified as a fluctuation-induced tunneling process. This indicates that the conductive region is not continuous but is formed by gold clusters embedded in the polymeric matrix. Above 70 K, instead, the data can be interpreted using a phenomenological model, which assumes an anomalous expansion of the conductive region upon decreasing the temperature, in the range from 300 to 200 K. The approach herein adopted, complemented with other characterizations, can provide useful information for the development of innovative and green optoelectronics.