Pluronic F-127: An Efficient Delivery Vehicle for 3-(1'-hexyloxy)ethyl-3-devinylpyropheophorbide-a (HPPH or Photochlor)

Micellar solution of [223Ra]RaCl2: Reaching renal excretion, potent efficacy in osteoblastic osteosarcoma in PDX model, biochemistry alterations and pharmacokinetics

Despite the successful use of the radiopharmaceutical radium-223 dichloride ([223Ra]RaCl2) for targeted alpha therapy of castration-resistant prostate cancer patients with bone metastases, some short-term side effects, such as diarrhea and vomiting, have been documented, causing patient discomfort. Hence, we prepared a nanosized micellar solution of [223Ra]RaCl2 and evaluated its biodistribution, pharmacokinetics, and induced biochemical changes in healthy mice up to 96 h after intraperitoneal administration as an alternative to overcome the previous limitations. In addition, we evaluated the bone specificity of micellar [223Ra]RaCl2 in patient-derived xenografts in the osteosarcoma model. The biodistribution studies revealed the high bone-targeting properties of the micellar [223Ra]RaCl2. Interestingly, the liver uptake remained significantly low (%ID/g = 0.1-0.02) from 24 to 96 h after administration. In addition, the micellar [223Ra]RaCl2 exhibited a significantly higher uptake in left (%ID/g = 0.85-0.23) and right (%ID/g = 0.76-0.24) kidneys than in small (%ID/g = 0.43-0.06) and large intestines (%ID/g = 0.24-0.09) over time, suggesting its excretion pathway is primarily through the kidneys into the urine, in contrast to the non-micellar [223Ra]RaCl2. The micellar [223Ra]RaCl2 also had low distribution volume (0.055 ± 0.003 L) and longer elimination half-life (28 ± 12 days). This nanosystem was unable to change the enzymatic activities of alanine aminotransferase, aspartate aminotransferase, gamma GT, glucose, and liquiform lipase in the treated mice. Finally, microscopic examination of the animals' osteosarcoma tumors treated with micellar [223Ra]RaCl2 indicated regression of the tumor, with large areas of necrosis. In contrast, in the control group, we observed tumor cellularity and cell anaplasia, mitotic figures and formation of neoplastic extracellular bone matrix, which are typical features of osteosarcoma. Therefore, our findings demonstrated the efficiency and safety of nanosized micellar formulations to minimize the gastrointestinal excretion pathway of the clinical radiopharmaceutical [223Ra]RaCl2, in addition to promoting regression of the osteosarcoma. Further studies must be performed to assess dose-response outcomes and organ/tissue dosimetry for clinical translation.

Dual-responsive in situ gelling polymer matrix for tunable ketamine general anesthesia in experimental animals

Animal experimentation is a critical part of the drug development process and pharmaceutical research. General anesthesia is one of the most common procedures. Careful administration and dosing of anesthetics ensure animal safety and study success. However, repeated injections are needed to maintain anesthesia, leading to adverse effects. Ketamine, a dissociative anesthetic, is commonly used for inducing anesthesia in animals and suffers from a short half-life requiring repeated dosing. Herein, we report a novel system for controlled anesthesia post-intraperitoneal administration. A polymer solution called "premix" was developed using two stimuli-responsive polymers, Pluronic (PF) and Carbopol (CP). As the premix was mixed with ketamine solution and injected, it underwent in situ gelation, hence controlling ketamine release and anesthesia. The PF and CP concentrations were optimized for the gelation temperature and viscosity upon mixing with the ketamine solution. The optimal premix/ketamine formulation (1.5:1) was liquid at room temperature and gel at physiological conditions with favorable mucoadhesion and rheology. Premix retarded the release of ketamine, translating to tunable anesthesia in vivo. Anesthesia duration and recovery were tunable per ketamine dose with minimal side effects. Therefore, we propose the implementation of PF/CP premix as a vehicle for general anesthesia in animals for optimal duration and effect.

Recent advances of Pluronic-based copolymers functionalization in biomedical applications

The design of polymeric biocompatible nanomaterials for biological and medical applications has received special attention in recent years. Among different polymers, the triblock type copolymers (EO)_x(PO)_y(EO)_x or Pluronics® stand out due its favorable characteristics such as biocompatibility, low tissue adhesion, thermosensitivity, and structural capacity to produce different types of macro and nanostructures, e.g. micelles, vesicles, nanocapsules, nanospheres, and hydrogels. However, Pluronic itself is not the "magic bullet" and its functionalization via chemical synthesis following biologically oriented design rules is usually required aiming to improve its properties. Therefore, this paper presents some of the main publications on new methodologies for synthetic modifications and applications of Pluronic-based nanoconstructs in the biomedical field in the last 15 years. In general, the polymer modifications aim to improve physical-chemical properties related to the micellization process or physical entrapment of drug cargo, responsive stimuli, active targeting, thermosensitivity, gelling ability, and hydrogel formation. Among these applications, it can be highlighted the treatment of malignant neoplasms, infectious diseases, wound healing, cellular regeneration, and tissue engineering. Functionalized Pluronic has also been used for various purposes, including medical diagnosis, medical imaging, and even miniaturization, such as the creation of lab-on-a-chip devices. In this context, this review discusses the main scientific contributions to the designing, optimization, and improvement of covalently functionalized Pluronics aiming at new strategies focused on the multiple areas of the biomedical field.

Thermosensitive Hydrogel Loaded with Nickel-Copper Bimetallic Hollow Nanospheres with SOD and CAT Enzymatic-Like Activity Promotes Acute Wound Healing

Various injury defense and repair functions are performed by the skin. Free radicals secreted after injury cause oxidative stress and inflammatory responses, which make wound healing difficult. However, the current metal nanomaterials for wound repair do not have sufficient catalytic activity or complex material design and cannot properly fit wounds. Therefore, it is imperative to develop more effective therapeutic approaches. This study investigated the effect of Ni₄Cu₂ hollow nanospheres composited with F127 hydrogel on promoting wound healing by applying them to wounds. Ni₄Cu₂ hollow nanospheres exhibited a superior spatial structure, contained many catalytic sites, and could be synthesized in a simple manner. In vitro experiments showed that Ni₄Cu₂ hollow nanospheres had superoxide dismutase-like activity and promoted fibroblast migration, angiogenesis, and macrophage polarization. F127, which is a thermosensitive, nontoxic, phase-change and porous hydrogel material, has proven to be an effective choice for injectable and sprayable medical dressings. Ni₄Cu₂ hollow nanospheres were mixed with F127 hydrogel without significantly affecting its performance. In addition to adapting to the complex, irregular gaps of acute wounds, the mixture lengthened the nanozyme release time, which enhanced healing. Based on the animal experiments, the Ni₄Cu₂/F127 composite hydrogel effectively promoted wound healing, epithelial regeneration, and the formation of skin appendages such as hair follicles in mice. Furthermore, the Ni₄Cu₂/F127 composite hydrogel was nontoxic to animals and had high biological safety. The Ni₄Cu₂/F127 composite hydrogel has provided an innovative strategy to develop composite hydrogels for the treatment of acute skin wounds.

Photodynamic Therapy in Combination with Doxorubicin Is Superior to Monotherapy for the Treatment of Lung Cancer

We have previously shown that a radioactive (123I)-analog of methyl 3-(1'-(iodobexyloxy) ethyl-3-devinylpyropheophorbide-a (PET-ONCO), derived from chlorophyll-a can be used for positron emission tomography (PET) imaging of a variety of tumors, including those where 18F-FDG shows limitations. In this study, the photodynamic therapy (PDT) efficacy of the corresponding non-radioactive photosensitizer (PS) was investigated in a variety of tumor types (NSCLC, SCC, adenocarcinoma) derived from lung cancer patients in mice tumor models. The in vitro and in vivo efficacy was also investigated in combination with doxorubicin, and a significantly enhanced long-term tumor response was observed. The toxicity and toxicokinetic profile of the iodinated PS was also evaluated in male and female Sprague-Dawley rats and Beagle dog at variable doses (single intravenous injections) to assess reversibility or latency of any effects over a 28-day dose free period. The no-observed-adverse-effect (NOAEL) of the PS was considered to be 6.5 mg/kg for male and female rats, and for dogs, 3.45 mg/kg, the highest dose levels evaluated, respectively. The corresponding plasma Cmax and AYClast for male and female rats were 214,000 and 229,000 ng/mL and 3,680,000 and 3,810,000 h * ng/mL, respectively. For male and female dogs, the corresponding plasma Cmax and AYClast were 76,000 and 92,400 ng/mL and 976,000 and 1,200,000 h * ng/mL, respectively.

Self-assembling synthetic nanoadjuvant scaffolds cross-link B cell receptors and represent new platform technology for therapeutic antibody production

Host antibody responses are pivotal for providing protection against infectious agents. We have pioneered a new class of self-assembling micelles based on pentablock copolymers that enhance antibody responses while providing a low inflammatory environment compared to traditional adjuvants. This type of "just-right" immune response is critical in the rational design of vaccines for older adults. Here, we report on the mechanism of enhancement of antibody responses by pentablock copolymer micelles, which act as scaffolds for antigen presentation to B cells and cross-link B cell receptors, unlike other micelle-forming synthetic block copolymers. We exploited this unique mechanism and developed these scaffolds as a platform technology to produce antibodies in vitro. We show that this novel approach can be used to generate laboratory-scale quantities of therapeutic antibodies against multiple antigens, including those associated with SARS-CoV-2 and Yersinia pestis, further expanding the value of these nanomaterials to rapidly develop countermeasures against infectious diseases.

Curcumin-loaded Pluronic® F-127 Micelles as a Drug Delivery System for Curcumin-mediated Photodynamic Therapy for Oral Application

Antimicrobial photodynamic therapy (aPDT) is promising for oral decontamination. Curcumin has been used as photosensitizer; however, the hydrophobic properties can negatively affect aPDT. This study evaluated the aPDT efficacy using Cur-loaded Pluronic^® F-127 micelles against Streptococcus mutans and Candida albicans biofilms. Micelles characterization was performed by zeta potential, dynamic light scattering, transmission electron microscopy, absorption and fluorescence spectroscopy. Cur concentrations, cell viability by CFU mL^-1 and confocal microscopy were determined. Data were analyzed by parametric and nonparametric tests under 5%. Cur-loaded Pluronic^® F-127 exhibited spherical shape, suitable particle size (≤100 nm), adequate polydispersity index, best stability, lower photodegradation and autoaggregation compared to unloaded-Cur. Both microorganisms were sensitive to Cur-loaded Pluronic^® F-127 micelles aPDT, with minimum inhibitory concentration (MIC) of 270 μm and 2.1093 μm for S. mutans and C. albicans suspended culture, respectively. Cur-loaded Pluronic^® F-127 aPDT exhibited antibacterial/antifungal effect against the biofilms (~3 log₁₀ reduction; P ≤ 0.05); however, similar to unloaded (P ≥ 0.05). Confocal images confirmed these results. Cur-loaded Pluronic^® F-127 micelles exhibited good photo-chemical properties and may be a viable alternative to deliver Cur and to improve aPDT effect during the treatment of dental caries. Moreover, Pluronic^® micelles can enhance the solubility, stability, permeability and control the release of Cur.

Probing the Interactions of Porphyrins with Macromolecules Using NMR Spectroscopy Techniques

Porphyrinic compounds are widespread in nature and play key roles in biological processes such as oxygen transport in blood, enzymatic redox reactions or photosynthesis. In addition, both naturally derived as well as synthetic porphyrinic compounds are extensively explored for biomedical and technical applications such as photodynamic therapy (PDT) or photovoltaic systems, respectively. Their unique electronic structures and photophysical properties make this class of compounds so interesting for the multiple functions encountered. It is therefore not surprising that optical methods are typically the prevalent analytical tool applied in characterization and processes involving porphyrinic compounds. However, a wealth of complementary information can be obtained from NMR spectroscopic techniques. Based on the advantage of providing structural and dynamic information with atomic resolution simultaneously, NMR spectroscopy is a powerful method for studying molecular interactions between porphyrinic compounds and macromolecules. Such interactions are of special interest in medical applications of porphyrinic photosensitizers that are mostly combined with macromolecular carrier systems. The macromolecular surrounding typically stabilizes the encapsulated drug and may also modify its physical properties. Moreover, the interaction with macromolecular physiological components needs to be explored to understand and control mechanisms of action and therapeutic efficacy. This review focuses on such non-covalent interactions of porphyrinic drugs with synthetic polymers as well as with biomolecules such as phospholipids or proteins. A brief introduction into various NMR spectroscopic techniques is given including chemical shift perturbation methods, NOE enhancement spectroscopy, relaxation time measurements and diffusion-ordered spectroscopy. How these NMR tools are used to address porphyrin-macromolecule interactions with respect to their function in biomedical applications is the central point of the current review.

Targeted Nanoparticles for Fluorescence Imaging of Folate Receptor Positive Tumors

This report presents the synthesis and folate receptor target-specificity of amino-functionalized polyacrylamide nanoparticles (AFPAA NPs) for near-infrared (NIR) fluorescence imaging of cancer. For the synthesis of desired nano-constructs, the AFPAA NPs (hereafter referred to as NPs) were reacted with a NIR cyanine dye (CD) bearing carboxylic acid functionality by following our previously reported approach, and the resulting conjugate (NP-CD) on further reaction with folic acid (FA) resulted in a new nano-construct, FA-NP-CD, which demonstrated significantly higher uptake in folate receptor-positive breast cancer cells (KB+) and in folate receptor over-expressed tumors in vivo. The target-specificity of these nanoparticles was further confirmed by inhibition assay in folate receptor-positive (KB+) and -negative (HT-1080) cell lines. To show the advantages of polyacrylamide (PAA)-based NPs in folate receptor target-specificity, the CD used in preparing the FA-NP-CD construct was also reacted with folic acid alone and the synthetic conjugate (CD-FA) was also investigated for its target-specificity. Interestingly, in contrast to NPs (FA-NP-CD), the CD-FA conjugate did not show any significant in vitro or in vivo specificity toward folate receptors, showing the advantages of PAA-based nanotechnology in delivering the desired agent to tumor cells.