Nb2O5 nanoparticles decorated with magnetic ferrites for wastewater photocatalytic remediation

Modified Silica Nanoparticles from Rice Husk Supported on Polylactic Acid as Adsorptive Membranes for Dye Removal

Industrial effluents and wastewater treatment have been a mainstay of environmental preservation and remediation for the last decade. Silica nanoparticles (SiO₂) obtained from rice husk (RH) are an alternative to producing low-cost adsorbent and agriculture waste recovery. One adsorption challenge is facilitating the adsorbate separation and reuse cycle from aqueous medium. Thus, the present work employs SiO₂ supported on polylactic acid (PLA) nanofibers obtained by the electrospinning method for Rhodamine B (RhB) dye adsorption. The silica surface was modified with trimethylsilyl chloride (TMCS) to increase affinity towards organic compounds. As a result, the silanized surface of the silica from rice husk (RHSil) promoted an increase in dye adsorption attributed to the hydrophobic properties. The PLA fibers containing 40% SiO₂ (w w^-1) showed about 85-95% capacity adsorption. The pseudo-first-order kinetic model was demonstrated to be the best model for PLA:SiO₂ RHSil nanocomposites, exhibiting a 1.2956 mg g^-1 adsorption capacity and 0.01404 min^-1 kinetic constant (k₁) value. In the reuse assay, PLA:SiO₂ membranes preserved their adsorption activity after three consecutive adsorption cycles, with a value superior to 60%. Therefore, PLA:SiO₂ nanocomposites from agricultural waste are an alternative to "low-cost/low-end" treatments and can be used in traditional treatment systems to improve dye removal from contaminated waters.

Pesticide pollutants in the environment - A critical review on remediation techniques, mechanism and toxicological impact

The excessive and unorganised utilisation of pesticides have posed negative impacts on soil and water at higher levels. Pesticides are a major class of persistent organic compounds with high resistance to natural biodegradation and enhanced tendency to bio accumulate. The severe health hazards imposed on the living organisms hinder the ecosystem and lead to chronic and irreversible health issues. Photocatalytic method is reported as a potential alternative with a variety of techniques and materials that are safer, easier, durable, cost-effective and efficient. Nanomaterials play a key role in this domain due to their versatility. In particular, nanostructured materials of organized shapes and morphological properties have gained enormous attention in research and real-time applications. Specifically, nanomaterials like nanotubes, nanorods and nanowires have unique properties and anisotropic structure that make them more suitable for treating pesticide wastes with photocatalysis. Variety of tuning methods and materials are emerging to enhance the activity of titanium and zinc based nanocatalysts in remediation methods. In the present article, four pesticides, namely, atrazine, chlorpyrifos, paraquat and naphthalene are chosen due to their common occurrence and usage in agricultural applications. These pesticides are highly toxic and need special attention to explore appropriate remediation methods. The report also details the latest innovations reported by several research studies in exploring the potential of specially synthesised nanoparticles for photocatalytic removal of pesticide pollutants from environment. For zinc-based hybrid nanomaterials, the maximum disintegration reported were 99%, 98%, 73.3% and 92.3% for atrazine, chlorpyrifos, paraquat and naphthalene, respectively.

CuO nanoparticles decorated on hydroxyapatite/ferrite magnetic support: photocatalysis, cytotoxicity, and antimicrobial response

Photocatalysts supported in magnetic nanocomposites for application in environmental remediation processes have been evaluated for removing contaminants due to easy recovery and low toxicity to the ecosystem. In this work, copper oxide (CuO) nanoparticles with photocatalytic properties were decorated on magnetic support constituted by hydroxyapatite (HAP) and ferrite to achieve efficiency in contaminated water remediation under visible light irradiation. First, nanomaterials were obtained by precipitation route, allowing fast and straightforward synthesis. Then, CuO nanoparticles with 6 nm diameter were efficiently decorated on magnetic support (25 nm), showing a high ability to absorb visible light irradiation (bandgap) to promote electronic transition and charge separation. Under visible irradiation, CuO promotes the H₂O₂ reduction in the conduction band (BC) to form hydroxyl radicals (^•OH), which are responsible for rhodamine B (RhB) dye degradation (> 90% in 60 min). Magnetic hysteresis assays confirmed the magnetic properties of HAP/ferrite support, which enabled the recovery and reuse of the magnetic photocatalyst efficiently up to 3 cycles. Due to low Cu²⁺ leaching after the photocatalytic application stage, cytotoxicity assay for the Allium cepa seeds did not exhibit abnormal cells other than those commonly found. Furthermore, the CuO-decorated nanoparticles showed bactericidal activity against S. aureus (Gram-positive) and E. coli (Gram-negative) microorganisms, being more significant for the first one. Thus, the developed nanocomposite of CuO nanoparticles decorated on the magnetic support surface showed to be a complete system for water remediation, acting in contaminant degradation under visible light irradiation and bactericidal control with environmentally friendly characteristics.Graphical abstract CuO nanoparticles decorated on hydroxyapatite/ferrite magnetic support acting as a photocatalytic and bactericidal system.

UV-Vis spectrophotometry coupled to chemometric analysis for the performance evaluation of atrazine photolysis and photocatalysis

In this study, a spectrophotometric-chemometric (Spec-Chem) approach was applied as an alternative to chromatography to monitor ATZ and by-products after photolytic and photocatalytic oxidation aiming to unveil the ATZ degradation mechanism. Spec-Chem is an accessible, easy-to-operate, low-cost analytical approach to monitor atrazine (ATZ) and by-products, and its applicability was validated by HPLC, the reference technique for the evaluation of pollutant degradation mechanisms. The chromatographic (DChro) and spectrophotometric (DSpec) data found 95% and 57% ATZ removal after 30 min, respectively, proving that the DSpec erroneously induces a 38% loss in removal efficiency. When DSpec was treated by multivariate curve resolution (MCR) analysis for providing chemometric data (DChem), it found ATZ removal and hydroxyatrazine (HAT) formation statistically equal to DChro (t-test, p = 0.05). After unraveling the ATZ degradation mechanism using Spec-Chem, a new hypothesis for the kinetic calculation of ATZ degradation was presented, where the concentrations of ATZ and HAT were used to find k and R² values representative for the ATZ degradation mechanism. The values found for k were compatible with the literature under similar conditions of ATZ degradation, and the linear correlation coefficients (R² = 0.99) showed an optimal fit for the proposed hypothesis. Thus, Spec-Chem was successfully applied to unravel the mechanism of photocatalytic degradation of ATZ in the presence of TiO₂, while k was obtained by the new hypothesis proposed that considered ATZ and HAT concentration as parameters of kinetic interest. Therefore, the importance of monitoring quantitatively ATZ and HAT were provided in this study, providing new information for the scientific community.

Potential of Nb2O5 nanofibers in photocatalytic degradation of organic pollutants

Various photocatalytic nanomaterials for environmental remediation have been promoted due to the pollution caused by different organic pollutants. In this study, Nb₂O₅ nanofibers were obtained by electrospinning technique, presenting controlled crystallinity and high specific surface area to improve the photoactivity response. The structural characterization indicated Nb₂O₅ nanofibers with orthorhombic phase formation. The photoluminescence measurements showed different energy levels contributing to the electronic transition events. The nanofibers with a bandgap up to 3.6 eV were applied to photocatalysis of dyes (rhodamine B (RhB) or methylene blue (MB)) and fluoxetine (FLX), listed as an emergent pollutant. In the optimized condition (pH = 9), the RhB and MB photocatalysis was 59% and 93% more efficient than photolysis due to ζ = - 50 mV ± 5 for EtOH_550 sample increased interaction with MB (cationic) compared to RhB unprotonated (pKa = 3.7). Therefore, FLX (pKa = 10.7) was selected due to protonated form at pH = 9 and showed 68% ± 1 adsorption in 30 min for EtOH_550. The FLX photocatalytic degradation under UV light irradiation was up to 17% higher than the photolytic degradation. The formation of hydroxyl radicals in the photocatalytic system (EtOH_550) was proven by the Coumarine probe assay, corroborating with the greater amount of α-[2-(methylamino)ethyl]benzylalcohol (MAEB), a by-product obtained after FLX oxidation. Additionally, the material achieved specific catalytic activity for the different organic compounds (RhB, MB, or FLX). Therefore, Nb₂O₅ nanofibers were efficient for degrading three different pollutants under UV light, proving a viable alternative for environmental remediation.

Preparation and Application of Nb2O5 Nanofibers in CO2 Photoconversion

Increasing global warming due to NOx, CO2, and CH4, is significantly harming ecosystems and life worldwide. One promising methodology is converting pollutants into valuable chemicals via photocatalytic processes (by reusable photocatalysts). In this context, the present work aimed to produce a Nb2O5 photocatalyst nanofiber system by electrospinning to convert CO2. Based on the collected data, the calcination at 600 ∘C for 2 h resulted in the best condition to obtain nanofibers with homogeneous surfaces and an average diameter of 84 nm. As a result, the Nb2O5 nanofibers converted CO2 mostly into CO and CH4, reaching values around 8.5 μmol g−1 and 0.55 μmol g−1, respectively.

Functionalized Magnetic Nanomaterials in Agricultural Applications

The development of functional nanomaterials exhibiting cost-effectiveness, biocompatibility and biodegradability in the form of nanoadditives, nanofertilizers, nanosensors, nanopesticides and herbicides, etc., has attracted considerable attention in the field of agriculture. Such nanomaterials have demonstrated the ability to increase crop production, enable the efficient and targeted delivery of agrochemicals and nutrients, enhance plant resistance to various stress factors and act as nanosensors for the detection of various pollutants, plant diseases and insufficient plant nutrition. Among others, functional magnetic nanomaterials based on iron, iron oxide, cobalt, cobalt and nickel ferrite nanoparticles, etc., are currently being investigated in agricultural applications due to their unique and tunable magnetic properties, the existing versatility with regard to their (bio)functionalization, and in some cases, their inherent ability to increase crop yield. This review article provides an up-to-date appraisal of functionalized magnetic nanomaterials being explored in the agricultural sector.