Real-time monitoring of fenitrothion in water samples using a silicon nanophotonic biosensor

Sensitivity enhancement of bimodal waveguide interferometric sensor based on regional mode engineering

In this paper, we propose a novel bimodal waveguide based on regional mode engineering (BiMW-RME). Leveraging the orthogonality of the guided modes, the form of patterned SiO2 cladding on the bimodal waveguide can reduce the interaction between the reference mode and the analyte, thereby significantly improving sensitivity. The proposed BiMW-RME sensor experimentally demonstrates a phase sensitivity of 2766 π rad/RIU/cm and a detection limit of 2.44×1-5 RIU. The sensitivity is 2.7 times higher than that of the conventional BiMW sensor on the same SOI platform. The proposed design strategy demonstrates a significant improvement in the sensor's sensitivity, presenting a novel approach to enhancing common-path interferometric sensor performance.

Nano-size cobalt-doped cerium oxide particles embedded into graphitic carbon nitride for enhanced electrochemical sensing of insecticide fenitrothion in environmental samples: An experimental study with the theoretical elucidation of redox events

In the present work, a nanocomposite, based on embedding Co-doped CeO2 nanoparticles into graphitic carbon nitride (g-C3N4), was applied to functionalize commercial glassy carbon paste. This is the first application of the electrochemical sensor, developed through the proposed procedure, in electrochemical sensing. The sensor was utilized for the electrochemical determination of organophosphate pesticide fenitrothion (FNT). Cyclic voltammetry identified reversible oxidation of FNT (oxidation at 0.18 V and reduction at 0.13 V) and additional reduction at -0.62 V vs. Ag/AgCl in HCl solution (pH = 1). Theoretical calculations were carried out to model and elucidate experimentally observed redox processes. Special attention was devoted to modeling experimental conditions, and based on the obtained results, a detailed redox mechanism of the investigated analyte was proposed. This represents the first complete and unambiguous elucidation of the FNT redox mechanism, supported by joined experimental and theoretical data. Square wave voltammetry (SWV) was utilized for quantification, whereby the FNT oxidation peak was chosen for monitoring the analyte concentration. The developed sensor provided a nanomolar detection limit (3.2 nmol L-1), a wide linear concentration range (from 0.01 to 13.7 μmol L-1), and good precision, repeatability, and selectivity towards FNT. Practical application possibility was explored by testing the sensor performance for examining tap water and apple samples. Recovery tests, conducted during the FNT-spiked sample assays, showed a great application capability of the developed sensor for real-time monitoring of FNT traces in environmental samples.

Disposable Device for Bacterial Vaginosis Detection

Due to the increasing demand for clinical testing of infectious diseases at the point-of-care, the global market claims alternatives for rapid diagnosis tools such as disposable biosensors, avoiding the need for specialized laboratories and skilled personnel. Bacterial vaginosis (BV) is an infectious disease that commonly affects reproductive-age women and predisposes the infection of sexually transmitted diseases. Especially in asymptomatic cases, BV can lead to pelvic inflammatory conditions, postpartum endometritis, and preterm labor. Conventionally, BV diagnosis involves the microscopic analysis of vaginal swab samples; it thus requires highly trained personnel. In response, we report a novel microfluidic paper-based analytical device for BV diagnosis. Sialidase, a biomarker overexpressed in BV, was detected by exploiting an immunosensing mechanism previously discovered by our team. This technology employs a graphene oxide-coated surface as a quencher of fluorescence; the fluorescence of the immunoprobes that do not experiment immunoreactions (antibody-antigen) are deactivated by graphene oxide via non-radiative energy transfer, whereas those immunoprobes undergoing immunoreactions preserve their photoluminescence due to the distance and the low affinity between the immunocomplex and the graphene oxide-coated surface. Our paper-based test was typically carried out within 20 min, and the sample volume was 6 μL. Besides, it was tested with 14 vaginal swabs specimens to discriminate clinical samples of women with normal microbiota from those with BV. Our disposable device represents a new tool to prevent the consequences of BV.

Integration of Metal-Organic Polyhedra onto a Nanophotonic Sensor for Real-Time Detection of Nitrogenous Organic Pollutants in Water

The grave health and environmental consequences of water pollution demand new tools, including new sensing technologies, for the immediate detection of contaminants in situ. Herein, we report the integration of metal-organic cages or polyhedra (MOCs/MOPs) within a nanophotonic sensor for the rapid, direct, and real-time detection of small (<500 Da) pollutant molecules in water. The sensor, a bimodal waveguide silicon interferometer incorporating Rh(II)-based MOPs as specific chemical receptors, does not require sample pretreatment and enables minimal expenditure of time and reagents. We validated our sensor for the detection of two common pollutants: the industrial corrosion inhibitor 1,2,3-benzotriazole (BTA) and the systemic insecticide imidacloprid (IMD). The sensor offers a fast time-to-result response (15 min), high sensitivity, and high accuracy. The limit of detection (LOD) in tap water for BTA is 0.068 μg/mL and for IMD, 0.107 μg/mL, both of which are below the corresponding toxicity thresholds defined by the European Chemicals Agency (ECHA). By combining innovative chemical molecular receptors such as MOPs with state-of-the-art photonic sensing technologies, our research opens the path to implement competitive sensor devices for in situ environmental monitoring.

Optical Biosensors and Their Applications for the Detection of Water Pollutants

The correct detection and quantification of pollutants in water is key to regulating their presence in the environment. Biosensors offer several advantages, such as minimal sample preparation, short measurement times, high specificity and sensibility and low detection limits. The purpose of this review is to explore the different types of optical biosensors, focusing on their biological elements and their principle of operation, as well as recent applications in the detection of pollutants in water. According to our literature review, 33% of the publications used fluorescence-based biosensors, followed by surface plasmon resonance (SPR) with 28%. So far, SPR biosensors have achieved the best results in terms of detection limits. Although less common (22%), interferometers and resonators (4%) are also highly promising due to the low detection limits that can be reached using these techniques. In terms of biological recognition elements, 43% of the published works focused on antibodies due to their high affinity and stability, although they could be replaced with molecularly imprinted polymers. This review offers a unique compilation of the most recent work in the specific area of optical biosensing for water monitoring, focusing on both the biological element and the transducer used, as well as the type of target contaminant. Recent technological advances are discussed.

Facile synthesis of petal-like VS2 anchored onto graphene nanosheets for the rapid sensing of toxic pesticide in polluted water

Fenitrothion (FT) is a toxic phosphorothioate insecticide that can easily contaminate aquatic environments, leading to a detrimental effect on the aquatic species and harmful endocrine disrupter effects on human health. Therefore, it is vital to develop a reliable methodology for the accurate and precise real-time sensing of carcinogenic FT in water samples at trace concentration to ensure environmental safety. We aim to fabricate the low-cost VS2-attached reduced graphene oxide (RGO) sheets via a simple hydrothermal approach. It was further applied for the rapid and accurate sensing of toxic FT. The VS2/RGO-composite delivers a more favorable microenvironment for the rapid electrocatalytic sensing performance towards toxic FT reduction than the VS2 and RGO modified electrodes. The electron transfer rate constant (ks) and the saturating absorption capacity (Γ) value of FT was evaluated to be 1.52 s-1 and 2.18 × 10-10 mol cm-2, respectively. The constructed sensor exhibits a wide linear relationship after amperometry between the cathodic current densities and the concentrations of FT in the range of 5-90 nM and high sensitivity (5.569 μA nM-1 cm-2); moreover, the detection limit was 0.07 nM (S/N = 3). The fabricated sensor has excellent anti-interference ability and reproducibility for the direct sensing of FT in river water, seawater, and lake water samples with acceptable recoveries. It is a promising sensing device for in-situ quantification of FT in agricultural products and ecological systems.