The Application of Micro-Analytical Techniques to Biomedical Analysis

Frequency-tuned contactless conductivity detector for the electrophoretic separation of clinical samples in capillaries with very small internal dimensions

An axial design of a capacitively coupled contactless conductivity detector was tested in combination with fused-silica capillaries with internal diameters of 10, 15, and 25 μm, which are used for high-efficiency electrophoretic separation. The transmission of the signal in the detection probe dependent on the specific conductivity of the solution in the capillary in the range 0-278 mS.m^-1 has a complex character and a minimum appears on the curve at very low conductivities. The position of the minimum of the calibration dependence gradually shifts with decreasing frequency of the exciting signal from 1.0 to 0.25 MHz toward lower specific conductivity values. The presence of a minimum on the calibration curves is a natural property of the axial design of contactless conductivity detector, demonstrated by solution of the equivalent electrical circuit of the detection probe, and is specifically caused by the use of shielding foil. The behavior of contactless conductivity detector in the vicinity of the minimum was documented for practical separations of amino acids in solutions of 3.2 M acetic acid with addition of 0-50% v/v methanol.

Measurement of Inflammatory Chemokines in Micro-dissected Tissue Biopsy Samples by Chip-Based Immunoaffinity Capillary Electrophoresis

To aid in the biochemical analysis of human skin biopsies, a chip-based immunoaffinity capillary electrophoresis (ICE) system has been developed for measuring inflammatory chemokines in micro-dissected areas of the biopsy. Following isolation of the areas of interest, the tissue was solubilized and the analytes of interest were isolated by the immunoaffinity disk within the chip. The captured analytes were labeled in situ with a 635 nm light-emitting laser dye and electro-eluted into the chip separation channel. Electrophoretic separation of all of the analytes was achieved in 2.5 min with quantification of each peak being performed by online LIF detection and integration of each peak area. The degree of accuracy and precision achieved by the chip-based system is comparable to conventional immunoassays and the system is robust enough to be applied to the analysis of clinical samples. Further, with the expanding array of antibodies that are commercially available, this chip-based system can be applied to a wide variety of different biomedical and clinical analyses.