Development of automated 3-dimensional tissue fabrication system Tissue Factory - Automated cell isolation from tissue for regenerative medicine

We have developed a new automated cell isolation system as one of the modules of automated cell sheet production system named Tissue-Factory (T-Factory). This system enables isolation of the target cells from tissue. Using this new system, we successfully isolated skeletal myoblast from skeletal muscle tissue. The cell isolation system makes us stably prepare cell suspension from each tissue automatically and safely. Isolation of skeletal myoblasts will contribute to labor-saving cell cultivation and operational stability, and lead further process in tissue engineering and regenerative medicine.

Fully automatic rapid DNA Ploidy Analyzer for intraoperative rapid diagnosis support

Frozen section studies are a useful method to rapidly define tumor malignancy and identify the extent of surgical resection. However, diagnosis with a frozen section is qualitative and sometimes difficult. Therefore a quantitative method for grading tumors is desired. We have already reported a technique of intraoperative flow cytometry (iFC) that supports intraoperative histopathological examination of frozen sections. In this study, we report an advanced system named "Fully Automatic Rapid DNA Ploidy Analyzer" with a tissue pretreatment function and a freeze-dried reagent kit for cell staining. To evaluate our system, we analyzed samples from glioma patients who underwent open surgery for brain tumors. We observed obvious difference of the Malignancy Index (MI) between neoplastic and perilesional brain tissue (26.0 ±22.1% and 4.1 ±2.5%, respectively, P<0.001). Cut-off level for identification of the tumor in the biopsy specimen was 6.8% which provided 86% sensitivity and 81% specificity. We also obtained a good correlation between the MI and histological grade (WHO grading). Our new system also enabled finishing the process from sample preparation to the end of analysis in ten minutes or less. These results demonstrate that our fully automatic rapid DNA ploidy analyzer is feasible for rapid determination of glioma presence in a surgical biopsy sample.

Flow cytometry as a diagnostic method for colorectal cancer

Intraoperative histopathological investigation plays an important role during surgery. Since the pathologist performs a diagnosis with a limited level of specimen, it may sometimes be difficult to reach a correct diagnosis. To improve the accuracy of the diagnosis, quantitative data from the whole specimen are helpful. It said that the detection capability for DNA aneuploidy (aneuploidy) is low for solid cancer compared with hematopoietic organ cancer. A new method that includes fresh tissue is introduced, the histogram from cancer tissue (cancer) and normal tissue (normal) is compared, new classification criteria are introduced, the Fast Fourier Transform (FFT) pattern (FFT pattern) obtained from FFT on the histogram is analyzed, and the area under the FFT pattern of the histogram (AUC) is compared. This method, named the "FFT-AUC method", which includes comparisons of AUC and the FFT pattern, shows good results.

New automatic cell isolation system for flow cytometry: cell isolation unit and staining reagent kit

Flow cytometry is well-known cell analysis method and useful to gain quantitative information from cells in blood, however, it is not widely used for solid tissues in clinical settings. This is partly because it takes a long time to prepare samples and the operation can be complicated. To resolve these problems, we developed a new automatic cell isolation system which consists of cell isolation unit and staining reagent kit specialized for flow cytometry. With this new system, cell isolation can be done more rapidly and easily. By using this method, we could determine optimum condition to disintegrate porcine colon tissue and stain cells stably in 6 minutes. This result indicates that our method can provide analysis data within 10 minutes. We also evaluated our method in colorectal cancer patients, and the result was promising. All the data suggests that this method can support and facilitate rapid diagnosis.

Controlling the dissociative ionization of ethanol with 800 and 400nm two-color femtosecond laser pulses

Ethanol molecules were irradiated with a pair of temporally overlapping ultrashort intense laser pulses (10(13)-10(14) Wcm(2)) with different colors of 400 and 800 nm, and the dissociative ionization processes have been investigated. The yield ratio of the C-O bond breaking with respect to the C-C bond breaking was varied in the range of 0.17-0.53 sensitively depending on the delay time between the two laser pulses, and the absolute value of the yield of the C-O bond breaking was found to be increased largely when the Fourier-transform limited 800 nm laser pulse overlaps the stretched 400 nm laser pulse, demonstrating an advantage of the two-color intense laser fields in controlling chemical bond breaking processes.

Dissociative ionization of ethanol by 400nm femtosecond laser pulses

The dissociative ionization of ethanol in short-pulsed laser fields at approximately 400 nm is investigated. The yield ratio of the C-O bond breaking with respect to the C-C bond breaking increases sharply as the temporal width increases from 60 to 400 fs, and the yield ratio is two to three times as large as that at 800 nm in the entire pulse-width range of 60-580 fs. The enhancement of the C-O bond breaking of singly charged ethanol at 400 nm and the bond elongation prior to the Coulomb explosion of doubly charged ethanol occurring in the relatively weak light field intensity of 10(12)-10(13) W cm(2) is interpreted by the efficient light-induced coupling among the electronic states at the shorter wavelength of 400 nm. From the double pulse experiment, in which ethanol is irradiated with a pair of short pulses (<80 fs), the most efficient coupling occurs at Deltat=160 fs that is much earlier than Deltat=250 at 800 nm, where Deltat denotes the temporal separation of the two pulses, indicating that the nonadiabatic field-induced potential crossings of singly charged ethanol occurs much earlier at 400 nm than at 800 nm.

The effect on immunocytes of anodic oxide titanium after hydrothermal treatment

All dental root implants come in contact with the oral epithelium, and many complex factors are found to arise in this region. In order to perform a successful dental root implantation, it is necessary to clarify the interaction of the dental root implant material with the host defense mechanisms involved in the specific and nonspecific immune responses to many antigens in oral bacteria and their components. Recently, focusing on developing the dental root implant, the Nikon Corporation improved the surface characteristics of pure titanium even further by developing a hydroxyapatite (HA) layer formed on an anodic titanium oxide film containing Ca and P via hydrothermal treatment (SA treatment). However, since little is known about the effect of SA-treated pure titanium (HA/Ti) on the defense mechanisms of the oral membrane epithelium, we investigated (1) the in vitro proliferation of murine splenic B lymphocytes on the surface of HA/Ti in the presence of three lipopolysaccharide (LPS) concentrations and (2) interleukin-1alpha (IL-1alpha) production by the reaction of human peripheral blood mononuclear cells (PBM cells) on the surface of HA/Ti under the same concentrations. After culture, murine splenic lymphocytes were measured by uptake of 3H-thymidine, and cytokine release (IL-1alpha) from PBM cells was measured by ELISA. Results showed that HA/Ti had hardly any effect on the LPS-induced proliferation of B lymphocytes and IL-1alpha production. In vitro investigations of the effects of HA/Ti on the LPS-induced proliferation of murine splenic B lymphocytes and IL-1alpha from PBM cells might be a useful way of elucidating the defense mechanism between implants and the oral epithelium.

A comparative study on interactions of alpha-aminoisobutyric acid containing antibiotic peptides, trichopolyn I and hypelcin A with phosphatidylcholine bilayers

Interactions of alpha-aminoisobutyric acid containing antibiotic peptides, trichopolyn I and hypelcin A with phosphatidylcholine bilayers were investigated to obtain some basic information on their bioactive mechanisms. Trichopolyn I as well as hypelcin A induced the leakage of a fluorescent dye, calcein, entrapped in sonicated egg yolk L-alpha-phosphatidylcholine vesicles. A quantitative analysis revealed that both the binding affinity and the 'membrane-perturbing activity' of trichopolyn I to the vesicles are about one-third of those of hypelcin A. The conformations and the orientations of the peptide and lipid molecules in the membranes were studied using polarized Fourier transform infrared-attenuated total reflection spectroscopy, circular dichroism, and differential scanning calorimetry. In phosphatidylcholine bilayers, both peptides mainly conformed to helical structures irrespective of the membrane physical state (gel or liquid-crystalline). The helix axes, penetrating the hydrophobic region of the bilayers, were oriented neither parallel nor perpendicular to the membrane normal. The disruption in the lipid packing induced by the peptide insertion seems to be responsible for the leakage by these peptides.

Clinical application of dental implant with root of coated bioglass: short-term results

During the last 4 years 73 dental implants with root-coated bioglass to replace one to three teeth in the premolar and molar sites of the mandible were inserted. The bonding ratio between implant and bone was observed clinically 1 year after implantation and installation of the superior structure. This ratio measured 52.4% to 63.3%. An acoustoelectric tester was developed that advanced our skills. The emphasis was placed on a tight fit between implant and surrounding bone.