Effects of Virion and Salt Concentrations on the Raman Signatures of Filamentous Phages fd, Pf1, Pf3, and PH75

Isolation and genomic analysis of a type IV pili-independent Thermus thermophilus phage, φMN1 from a Japanese hot spring

A Thermus thermophilus lytic phage was isolated from a Japanese hot spring using a type IV pili-deficient strain as an indicator host, and designated as φMN1. Electron microscopic (EM) examination revealed that φMN1 had an icosahedral head and a contractile tail, suggesting that φMN1 belonged to Myoviridae. An EM analysis focused on φMN1 adsorption to the Thermus host cell showed that the receptor molecules for the phage were uniformly distributed on the outer surface of the cells. The circular double-stranded DNA of φMN1 was 76,659 base pairs in length, and the guanine and cytosine content was 61.8%. It was predicted to contain 99 open reading frames, and its putative distal tail fiber protein, which is essential for non-piliated host cell surface receptor recognition, was dissimilar in terms of sequence and length with its counterpart in the type IV pili-dependent φYS40. A phage proteomic tree revealed that φMN1 and φYS40 are in the same cluster, but many genes had low sequence similarities and some seemed to be derived from both mesophilic and thermophilic organisms. The gene organization suggested that φMN1 evolved from a non-Thermus phage through large-scale recombination events of the genes determining the host specificity, followed by gradual evolution by recombination of both the thermophilic and mesophilic DNAs assimilated by the host Thermus cells. This newly isolated phage will provide evolutionary insights into thermophilic phages.

Comparative study on the inactivation of MS2 and M13 bacteriophages using energetic femtosecond lasers

Femtosecond (fs) laser irradiation techniques are emerging tools for inactivating viruses that do not involve ionizing radiation. In this work, the inactivation of two bacteriophages representing protective capsids with different geometric constraints, that is, the near-spherical MS2 (with a diameter of 27 nm) and the filamentous M13 (with a length of 880 nm) is compared using energetic visible and near-infrared fs laser pulses with various energies, pulse durations, and exposure times. Intriguingly, the results show that inactivation using 400 nm lasers is substantially more efficient for MS2 compared to M13. In contrast, using 800 nm lasers, M13 was slightly more efficiently inactivated. For both viruses, the genome was exposed to a harmful environment upon fs-laser irradiation. However, in addition to the protection of the genome, the metastable capsids differ in many properties required for stepwise cell entry that may explain their dissimilar behavior after (partial) disassembly. For MS2, the dominant mechanism of fs-laser inactivation was the aggregation of the viral capsid proteins, whereas aggregation did not affect M13 inactivation, suggesting that the dominant mechanism of M13 inactivation was related to breaking of secondary protein links.

Physiological Properties and Genome Structure of the Hyperthermophilic Filamentous Phage φOH3 Which Infects Thermus thermophilus HB8

A filamentous bacteriophage, φOH3, was isolated from hot spring sediment in Obama hot spring in Japan with the hyperthermophilic bacterium Thermus thermophilus HB8 as its host. Phage φOH3, which was classified into the Inoviridae family, consists of a flexible filamentous particle 830 nm long and 8 nm wide. φOH3 was stable at temperatures ranging from 70 to 90°C and at pHs ranging from 6 to 9. A one-step growth curve of the phage showed a 60-min latent period beginning immediately postinfection, followed by intracellular virus particle production during the subsequent 40 min. The released virion number of φOH3 was 109. During the latent period, both single stranded DNA (ssDNA) and the replicative form (RF) of phage DNA were multiplied from min 40 onward. During the release period, the copy numbers of both ssDNA and RF DNA increased sharply. The size of the φOH3 genome is 5688 bp, and eight putative open reading frames (ORFs) were annotated. These ORFs were encoded on the plus strand of RF DNA and showed no significant homology with any known phage genes, except ORF 5, which showed 60% identity with the gene VIII product of the Thermus filamentous phage PH75. All the ORFs were similar to predicted genes annotated in the Thermus aquaticus Y51MC23 and Meiothermus timidus DSM 17022 genomes at the amino acid sequence level. This is the first report of the whole genome structure and DNA multiplication of a filamentous T. thermophilus phage within its host cell.

Complete chemical shift assignment of the ssDNA in the filamentous bacteriophage fd reports on its conformation and on its interface with the capsid shell

The fd bacteriophage is a filamentous virus consisting of a circular single-stranded DNA (ssDNA) wrapped by thousands of copies of a major coat protein subunit (the capsid). The coat protein subunits are mostly α-helical and curved, and are arranged in the capsid in consecutive pentamers related by a translation along the main viral axis and a rotation of ~36° (C5S2 symmetry). The DNA is right-handed and helical, but information on its structure and on its interface with the capsid is incomplete. We present here an approach for assigning the DNA nucleotides and studying its interactions with the capsid by magic-angle spinning solid-state NMR. Capsid contacts with the ssDNA are obtained using a two-dimensional (13)C-(13)C correlation experiment and a proton-mediated (31)P-(13)C polarization transfer experiment, both acquired on an aromatic-unlabeled phage sample. Our results allow us to map the residues that face the interior of the capsid and to show that the ssDNA-capsid interactions are sustained mainly by electrostatic interactions between the positively charged lysine side chains and the phosphate backbone. The use of natural abundance aromatic amino acids in the growth media facilitated the complete assignment of the four nucleotides and the observation of internucleotide contacts. Using chemical shift analysis, our study shows that structural features of the deoxyribose carbons reporting on the sugar pucker are strikingly similar to those observed recently for the Pf1 phage. However, the ssDNA-protein interface is different, and chemical shift markers of base pairing are different. This experimental approach can be utilized in other filamentous and icosahedral bacteriophages, and also in other biomolecular complexes involving structurally and functionally important DNA-protein interactions.

Filamentous virus decoration with gold nanoparticles: global fingerprints of bionanocomposites acquired with SERS

A bioconjugation reaction is used to obtain fd viruses with one gold nanoparticle at the tip and gold nanowire-like structures.

Bacteriophage-induced aggregation of oil sands tailings

Very large quantities of tailings are produced as a result of processing oil sands. After the sand particles settle out, a dense stable mixture of clay, silt, water with residual bitumen, salts, and organics called mature fine tailings (MFT) can remain in suspension for decades. Research into developing methods that would allow consolidation and sedimentation of the suspended particles is ongoing. We have studied the ability of a filamentous bacteriophage (called VP12 bearing the peptide DSQKTNPS at the N-terminus of the major coat protein pVIII) to aggregate MFT. To understand the biophysical basis of the aggregation, phage-induced aggregation of diluted MFT was measured at room temperature under varying conditions of pH, salt, detergent. Phage at concentrations of 5.0 × 10(11)/mL to 10(12)/mL induced rapid settling of the diluted MFT. The addition of sodium chloride (10 mM) lowered the concentration of phage required to induce aggregation. Since the non-ionic detergents Triton-X 100 and Tween-20, and the ionic detergent sodium deoxycholate had little effect, hydrophobic interactions do not appear to be a major contributor to the phage-induced aggregation of MFT. However, aggregation was prevented at pH values higher than 9.0 suggesting that positively charged amino acid residues are required for MFT aggregation by phage. Genetic engineering of the pVIII peptide sequence indicated that hydrogen bonding also contributes to phage-induced aggregation. In addition, replacing the basic residue lysine with an alanine in the recombinant peptide of VP12 completely prevented phage-induced aggregation. Three other phage displaying different amino acid sequences but all containing a lysine in the same position had variable aggregation efficiencies, ranging from no aggregation to rapid aggregation. We conclude that not only are the functional groups of the amino acids important, but the conformation that is adopted by the variable pVIII peptide is also important for phage-induced MFT aggregation.

A structural model for the single-stranded DNA genome of filamentous bacteriophage Pf1

The filamentous bacteriophage Pf1, which infects strain PAK of Pseudomonas aeruginosa, is a flexible filament ( approximately 2000 x 6.5 nm) consisting of a covalently closed DNA loop of 7349 nucleotides sheathed by 7350 copies of a 46-residue alpha-helical subunit. The subunit alpha-helices, which are inclined at a small average angle ( approximately 16 degrees ) from the virion axis, are arranged compactly around the DNA core. Orientations of the Pf1 DNA nucleotides with respect to the filament axis are not known. In this work we report and interpret the polarized Raman spectra of oriented Pf1 filaments. We demonstrate that the polarizations of DNA Raman band intensities establish that the nucleotide bases of packaged Pf1 DNA are well ordered within the virion and that the base planes are positioned close to parallel to the filament axis. The present results are combined with a previously proposed projection of the intraviral path of Pf1 DNA [Liu, D. J., and Day, L. A. (1994) Science 265, 671-674] to develop a novel molecular model for the Pf1 assembly.

Glycerol facilitates the disaggregation of recombinant adeno-associated virus serotype 2 on mica surface

Preparation of distributed virus on a solid substrate is a prerequisite for investigation of the properties and individualism of virus, while many previous studies showed that virus has a tendency to aggregate on solid substrates. In this communication, we report a novel approach by which well-separated recombinant adeno-associated virus serotype 2 (rAAV2) could be prepared on bare mica surface. The key technique in this approach is the addition of less than 3% (v/v) glycerol into the virus solution and subsequently deposition onto mica surface for the sample preparation. The possible mechanisms are also briefly discussed.

The Structure of a Filamentous Bacteriophage

Many thin helical polymers, including bacterial pili and filamentous bacteriophage, have been seen as refractory to high-resolution studies by electron microscopy. Studies of the quaternary structure of such filaments have depended upon techniques such as modeling or X-ray fiber diffraction, given that direct visualization of the subunit organization has not been possible. We report the first image reconstruction of a filamentous virus, bacteriophage fd, by cryoelectron microscopy. Although these thin ( approximately 70 A in diameter) rather featureless filaments scatter weakly, we have been able to achieve a nominal resolution of approximately 8 A using an iterative helical reconstruction procedure. We show that two different conformations of the virus exist, and that in both states the subunits are packed differently than in conflicting models previously proposed on the basis of X-ray fiber diffraction or solid-state NMR studies. A significant fraction of the population of wild-type fd is either disordered or in multiple conformational states, while in the presence of the Y21M mutation, this heterogeneity is greatly reduced, consistent with previous observations. These results show that new computational approaches to helical reconstruction can greatly extend the ability to visualize heterogeneous protein polymers at a reasonably high resolution.

Affinity-selected filamentous bacteriophage as a probe for acoustic wave biodetectors of Salmonella typhimurium

Proof-in-concept biosensors were prepared for the rapid detection of Salmonella typhimurium in solution, based on affinity-selected filamentous phage prepared as probes physically adsorbed to piezoelectric transducers. Quantitative deposition studies indicated that approximately 3 x 10(10)phage particles/cm(2) could be irreversibly adsorbed for 1 h at room temperature to prepare working biosensors. The quality of phage deposition was monitored by fluorescent microscopy. Specific-bacterial binding resulted in resonance frequency changes of prepared sensors, which were evaluated using linear regression analysis. Sensors possessed a rapid response time of <180 s, had a low-detection limit of 10(2)cells/ml and were linear over a range of 10(1)-10(7)cells/ml with a sensitivity of 10.9 Hz per order of magnitude of S. typhimurium concentration. Viscosity effects due to increasing bacterial concentration and non-specific binding were not significant to the piezoelectric platform as confirmed by dose-response analysis. Phage-bacterial binding was confirmed by fluorescence and scanning electron microscopy. Overall, phage may constitute effective bioreceptors for use with analytical platforms for detecting and monitoring bacterial agents, including use in food products and possibly biological warfare applications.