Cellular responses to gravity: extracellular, intracellular and in-between

Altered growth and radiosensitivity in neural precursor cells subjected to oxidative stress

PURPOSE

To determine whether changes in oxidative stress could enhance the sensitivity of neural precursor cells to ionizing radiation.

MATERIALS AND METHODS

Two strategies were used whereby oxidative stress was modulated endogenously, through manipulation cell culture density, or exogenously, through direct addition of hydrogen peroxide.

RESULTS

Cells subjected to increased endogenous oxidative stress through low-density growth routinely exhibited an inhibition of growth following irradiation. However, cells subjected to chronic exogenous oxidative treatments showed increased sensitivity to proton and gamma-irradiation compared to untreated controls. Reduced survival of irradiated cultures subjected to oxidizing conditions was corroborated using enzymatic viability assays, and was observed over a range of doses (1 - 5 Gy) and post-irradiation re-seeding densities (20 - 200 K/plate).

CONCLUSIONS

Collectively our results provide further support for the importance of redox state in the regulation of neural precursor cell function, and suggest that oxidative stress can inhibit the proliferative potential of cells through different mechanisms. This is likely to compromise survival and under conditions where excess exogenous oxidants might predominate, sensitivity to irradiation may be enhanced.

A major effect of simulated microgravity on several stages of preimplantation mouse development is lethality associated with elevated phosphorylated SAPK/JNK

We tested whether microgravity affects mouse development during a period when gravity cues chick and frog embryo development. A rotating vessel developed approximately 0.1% simulated microgravity (MGS) for embryos. Microgravity simulation resulted in blocked cell accumulation in E2.5 embryos. E1.5 and E3.5 embryos showed lesser effects. For E1.5/2.5 embryos, cell accumulation block was followed by lethality at 48 hours after MGS. For E3.5 embryos, MGS blocked development without lethality but with apoptosis. E1.5-3.5 embryos from the rotational control developed lesser effects than MGS embryos. Embryonic stress-activated protein kinase (SAPK) was phosphorylated during MGS and mediated apoptosis. Increased pSAPK suggested that lethality is due to cellular stress induced by MGS, unlike the dysfunctional development after gravitational disorientation in frog and chick embryos. Thus, MGS causes lethality, a novel phenotype not often observed in microgravity or MGS. Embryonic lethality at E2.5 and apoptosis at E3.5 are associated with SAPK function, suggesting that MGS causes a general stress response that immediately affects many aspects of development. In addition, MGS and many aspects of In vitro fertilization/assisted reproductive technologies (IVF/ART) produce nonphysiological, nonevolutionary stresses that are mediated by SAPK, suggesting the primacy of this protein kinase in a wide range of mechanisms mediating negative reproductive outcomes in IVF/ART and potentially in spaceflight.

Buoyant plumes from solute gradients generated by non-motile Escherichia coli

The effect of hydrodynamic mixing in bacterial populations due to bacterial chemotaxis is a well-described phenomenon known as bioconvection. Here we report the observation of buoyant plumes that result in hydrodynamic mixing, but in contrast to bioconvection the plumes form in the absence of bacterial motility. We propose that the buoyant flow originates from solute gradients created by bacterial metabolism, similar to solute-induced buoyant flow around growing protein crystals. In our experiments, metabolically-active non-motile Escherichia coli were layered along the bottom of flat-bottomed containers. The E. coli consumed glucose in the medium creating a lighter fluid beneath a heavier fluid. The situation is an example of Rayleigh-Taylor instability, in which a lighter fluid pushes on a heavier one. We developed a numerical model to study the effect of E. coli nutrient consumption and by-product excretion on extracellular solute gradients. The model solutions showed reduced-density fluid along the bottom of the fluid domain leading to buoyant plumes, which were qualitatively similar to the experimental plumes. We also used scaling analyses to study the dependence of plume formation on container size and cell size, and to investigate the effect of reduced gravity, such as the microgravity conditions encountered during spaceflight.

Escherichia coli growth under modeled reduced gravity

Bacteria exhibit varying responses to modeled reduced gravity that can be simulated by clino-rotation. When Escherichia coli was subjected to different rotation speeds during clino-rotation, significant differences between modeled reduced gravity and normal gravity controls were observed only at higher speeds (30-50 rpm). There was no apparent affect of removing samples on the results obtained. When E. coli was grown in minimal medium (at 40 rpm), cell size was not affected by modeled reduced gravity and there were few differences in cell numbers. However, in higher nutrient conditions (i.e., dilute nutrient broth), total cell numbers were higher and cells were smaller under reduced gravity compared to normal gravity controls. Overall, the responses to modeled reduced gravity varied with nutrient conditions; larger surface to volume ratios may help compensate for the zone of nutrient depletion around the cells under modeled reduced gravity.

Optimized suspension culture: the rotating-wall vessel

Suspension culture remains a popular modality, which manipulates mechanical culture conditions to maintain the specialized features of cultured cells. The rotating-wall vessel is a suspension culture vessel optimized to produce laminar flow and minimize the mechanical stresses on cell aggregates in culture. This review summarizes the engineering principles, which allow optimal suspension culture conditions to be established, and the boundary conditions, which limit this process. We suggest that to minimize mechanical damage and optimize differentiation of cultured cells, suspension culture should be performed in a solid-body rotation Couette-flow, zero-headspace culture vessel such as the rotating-wall vessel. This provides fluid dynamic operating principles characterized by 1) solid body rotation about a horizontal axis, characterized by colocalization of cells and aggregates of different sedimentation rates, optimally reduced fluid shear and turbulence, and three-dimensional spatial freedom; and 2) oxygenation by diffusion. Optimization of suspension culture is achieved by applying three tradeoffs. First, terminal velocity should be minimized by choosing microcarrier beads and culture media as close in density as possible. Next, rotation in the rotating-wall vessel induces both Coriolis and centrifugal forces, directly dependent on terminal velocity and minimized as terminal velocity is minimized. Last, mass transport of nutrients to a cell in suspension culture depends on both terminal velocity and diffusion of nutrients. In the transduction of mechanical culture conditions into cellular effects, several lines of evidence support a role for multiple molecular mechanisms. These include effects of shear stress, changes in cell cycle and cell death pathways, and upstream regulation of secondary messengers such as protein kinase C. The discipline of suspension culture needs a systematic analysis of the relationship between mechanical culture conditions and biological effects, emphasizing cellular processes important for the industrial production of biological pharmaceuticals and devices.